**After flashing of the firmware comes this error！**

#1

Hello everyone!

Now I have a problem which I can’t solve is:

After I “updated” the firmware without intention, I can’t set voltage signal at all.

The attachment is the picture of the error bar.

Any advices and suggestions are welcomed!

Thank you so much!

Best regards!

Shuhua Meng

#2

Hello Shuhua,

I am sorry to hear about the trouble. I did not see the attachment you referred to. Would you mind trying to attach it again? It will help to get an idea of what is going on.

Thanks,
Christian

#3

Hello Christian,

Thanks so much for your reply, the attachment is below.

Again thank you so much!

Best regards!

Shuhua

在 2017年2月21日星期二 UTC+1下午2:11:22，Christian Fobel写道：

···

Hello Shuhua,
I am sorry to hear about the trouble. I did not see the attachment you referred to. Would you mind trying to attach it again? It will help to get an idea of what is going on.

Thanks,
Christian

#4

Hello Shuhua,

I am sorry to hear about the trouble. I did not see the attachment you referred to. Would you mind trying to attach it again? It will help to get an idea of what is going on.

Thanks,
Christian

#5

在 2017年2月21日星期二 UTC+1下午2:35:30，Christian Fobel写道：

···

Hello Shuhua,
I am sorry to hear about the trouble. I did not see the attachment you referred to. Would you mind trying to attach it again? It will help to get an idea of what is going on.

Thanks,
Christian