Hardware   DropBot v2


HV channel test and Calibration (2)
setting up dropbot: set_waveform_voltage(xxx) -> BAD VLAUE (5)
Error at starting up microdrop system (4)
HV Switching Board not detected by Control board (1)
Problem powering up DropBot System (2)
Dropbot Case for Laser Cutting by Ponoko (1)
Problems with HV Switching Board Channels (1)
PCB Assembly Failures (1)
Problem Powering Up Signal Generator Board to Flash (1)
HELP? What to do when the signal generator acts weird? (10)
Can't connect to the device. (19)
Channel testing gives odd results (1)
DropBot as a measuring tool? Alternative uses? (3)
DMF Device Connector Modifications - Micro-Switch for Safety Interlock (4)
Errors while burning bootloader to signal generator board (6)
(temp.) deactivation of broken, shorted or suspicious channels? (2)
Failed to reach specified voltage (5)
120-channel device connector (3)
weird channel readings during switching board tests (3)
Improve jumper images on the wiki (3)
Several "little" things: a) chip breakdowns b) maximum-voltage c) feedback d) too small topsubstrate (5)
Control Board Flashing "Import Error: No Module named upload" (12)
OpenDrop support and next-gen DropBot dev (3)
can't flash signal generator board (3)
ISP connector on control board (1)
Problems powering up ( 2 ) (23)
DIY DropBot roll call (7)
Recommended fixes by the manufacturer of my boards (4)
Control Board Firmware (4)
Control board setup - flashing firmware (1)